Vacancy caducado!
Description: Join the Lockheed Martin Field Sustainment Team as an Airframe and Powerplant Systems Field Service Engineer (FSE) at our Warner Robins, Georgia Aircraft Logistic Center (ALC). This position will advise/assist the customer on all matters pertaining to the daily maintenance, inspection, logistics, and operation of the C-5 aircraft and its installed utility systems. This position also requires extensive C-5 aircraft systems experience. Experience in troubleshooting, operation, modification and inspection methods relative to the installed systems is essential. Position involves significant interface with customer personnel at all levels; excellent communication skills, both oral and written, are required.Other responsibilities include but are not limited to the following: Provide on-site/on-equipment engineering assistance and technical advice including investigation, engineering analysis and interpretation of results to customer personnel. Assist the customer on all aspects of equipment operations including installation, maintenance and operation techniques, adjustment, calibration, trouble shooting, bench check, routine maintenance, inspection and intermediate level repair. Provide advice in the identification of and instruction on the use of special tools, handling equipment and test equipment associated with the C-5 aircraft. Provide advice and assistance on the use and interpretation of C-5 technical orders, Engineering Change Proposals (ECPs) and other related technical publications. Provide on-going surveillance of shop maintenance and safety practices; provide technical advice and recommend corrective measures necessary to ensure adequate maintenance and safety procedures are followed to minimize future problems. Assist the customer in troubleshooting of unusual and difficult maintenance issues associated with C-5 aircraft. Analyze maintenance problems and suggest improvements where indicated. Provide liaison between customer, Original Equipment Manufacturer (OEM) and Depot on related maintenance and operational problems. Provide advice as requested to assist in accident investigation and preparing failure reports. Candidate must be willing to travel and accept assignment to any location for which selected. Must possess at minimum an Interim Secret Security Clearance prior to starting. Applicants selected will be subject to a government security investigation and must meet eligibility requirements for access to classified information. Serve as a liaison function between the Warner Robins Engineering and Lockheed Martin Aeronautics Engineering teams.aeroafsBasic Qualifications:The following Basic Qualifications are skills that a candidate must possess to be considered for this position: C-5 airframe, power plant, and utility systems experience. System troubleshooting, drawing/schematic reading experienceDesired Skills:The following Desired Skills are not required but are those skills that would set a candidate apart from the other candidates: Extensive C-5 experience. Aircraft engineering experience. Planning and scheduling activities. Excellent communication SkillsSecurity Clearance Statement: This position requires a government security clearance, you must be a US Citizen for consideration.Clearance Level: SecretOther Important Information You Should KnowExpression of Interest: By applying to this job, you are expressing interest in this position and could be considered for other career opportunities where similar skills and requirements have been identified as a match. Should this match be identified you may be contacted for this and future openings.Ability to Work Remotely: Onsite Full-time: The work associated with this position will be performed onsite at a designated Lockheed Martin facility.Work Schedules: Lockheed Martin supports a variety of alternate work schedules that provide additional flexibility to our employees. Schedules range from standard 40 hours over a five day work week while others may be condensed. These condensed schedules provide employees with additional time away from the office and are in addition to our Paid Time off benefits.Schedule for this Position: Non- standard 40 hour work week as assigned by leaderLockheed Martin is an Equal Opportunity/Affirmative Action Employer. All qualified applicants will receive consideration for employment without regard to race, color, religion, sex, pregnancy, sexual orientation, gender identity, national origin, age, protected veteran status, or disability status.The application window will close in 90 days; applicants are encouraged to apply within 5 - 30 days of the requisition posting date in order to receive optimal consideration.At Lockheed Martin, we use our passion for purposeful innovation to help keep people safe and solve the world's most complex challenges. Our people are some of the greatest minds in the industry and truly make Lockheed Martin a great place to work.With our employees as our priority, we provide diverse career opportunities designed to propel, develop, and boost agility. Our flexible schedules, competitive pay, and comprehensive benefits enable our employees to live a healthy, fulfilling life at and outside of work. We place an emphasis on empowering our employees by fostering an inclusive environment built upon integrity and corporate responsibility.If this sounds like a culture you connect with, you’re invited to apply for this role. Or, if you are unsure whether your experience aligns with the requirements of this position, we encourage you to search on Lockheed Martin Jobs , and apply for roles that align with your qualifications.Experience Level: Experienced ProfessionalBusiness Unit: AERONAUTICS COMPANYRelocation Available: PossibleCareer Area: Product SupportType: Full-TimeShift: First
Vacancy caducado!