Yar-Craft

Job Description: Yar-Craft Job Purpose:We are looking for hardworking individuals to apply to grind edges off de-molded parts and inside of hulls. Cuts and drills necessary holes in hulls and decks.  Inspects all boats after production to ensure that all parts are complete and up to quality standards. Performs all assembly and disassembly. Our Yar-Craft team assembles everything in their own building, from boxing to finish, Yar-Craft does it all.Job Details:This is a first shift position, and the hours are from 6:00 am to 2:30 pmStarting pay for this position is $14.40/hourAll positions are safety sensitive. A safety sensitive position is any position designated in writing by an employer, in which a person performing the position while under the influence of marijuana may constitute a threat to health or safety.Qualified candidates will be asked to submit to drug testing. Key Duties and Responsibilities: Be able to identify read orders and identify missing or defective parts and be able to replace when necessary if production is not availableBe able to use and maintain a variety of hand tools including screw gun, drill, etc.Must have strong attention to detailKeep work area clean and orderlyFollow instruction of Supervisor/foreman/leadWiring AreaBe able to cut all holes to run wires/panels/graphsInstall premade harnessesInstall lights/switches/dashes/graphsBuild consoles and installWire bow sectionClean at end of dayTank AreaCut boat outInstall pumps/tanks/plumbing/wiring back end/jack plates/battery charger/battery boxesClean at end of dayWiring Harness AreaLay out/build wiring harness/blocks/graph harness/trolling motor harnessesVery technical/intricate – ability to have strong attention to detail/instructionsCarpet AreaBe able to install carpet according to order using strong adhesive glue.Be able to install carpet in both boats and lidsLids AreaInstall locks/hinges on lids/shocksMount all lids/finish components/rod box organizers/rod straps and bucklesMounting AreaInstall trolling motors/flush mounts/seatsInstall rub rail/silicone/end capsBoxing AreaBe able to grind all de-molded parts properly (hulls, decks, small parts).Be able to lift deck parts with the help of other employees and move to cut & gear area.Be able to drill foam chambers/foam them/skip grind/sand areas foamed.Be able to lift/set rail/hull together/glass/sand all areas/paint where needed.Wipe down, clean, and inspect before sending boat to Finish Department.Keep work area clean and orderlyFollow instruction of Supervisor/foreman/leadMust be able to wear safety glasses and hearing protection.Perform other duties, assignments and responsibilities as needed.