We are in need of an experience EMT installer on exterior residential walls, both framed and masonry. You must have your own truck tools and experience. Any training by us is specific to the appliance and simple but must be sized and done right the first time.
We install exterior appliances needing an exterior (occasionally an attic) run from the main panel to the disconnect box.
Virtually every run is in 1/2" EMT on the outside of the house.
The position is available immediately to the right installer
The work being done is Valleywide.
Each run varies in length from 10' to the other side of the house. There will need to be a breaker installed and if the panel is full then you need to have the experience and supplies on site to be able to overcome a full panel. We use 12ga exclusively as rarely is a circuit over 20amps in capacity.
Payment is made per foot from the main panel and some are more challenging than others. You do not need to be licensed as you will be working under ours. This means you must possess an understanding and adhere to local and State electrical codes doing this work.
This is a legit offer and while on the job site your appearance will be a reflection of a quality, trusted company and if you can pull that off, reply with your experience level and a good reason we should consider employing you.