I&E Technician

Install, troubleshoot, maintain, clean, and overhaul electrical, electro-mechanical and electronic digital systems including 110-220-440 volt single and three-phase electrical distribution, disconnect starters and push button stations, ignition wiring systems, control circuits on boilers, combustion equipment, batch weighing and automatic processing equipment, sequential digital logic and distributed digital and analog process control systems.Calibrate and troubleshoot a wide range of instruments consisting of pneumatic, electronic, and digital modes including pressure, level, temperature and pH controllers and recorders, gas analyzers, weigh cells, air operated valves, electronic probes, programmable controllers, digital and analog controllers, mass flow devices, speed control, pulse flow devices, nuclear measurement devices, etc.Repair, install, and maintain all plant equipment, buildings, utilities, and services.Ability to interface with PLCs and DCS for troubleshooting, lockouts, calibrations, checkouts, or process changes such as adding alarms or adjusting alarm setpoints.  Some working knowledge of DCS logic and programming to support these activities.Identify specific parts and supplies needed for specific jobs and obtain from the storeroom.  Place orders when additional parts are needed.Enter information into the Computerized Maintenance Management System to document work completed, equipment condition, and time reporting.Notify the manager of any circumstances that will require additional parts, assistance, further investigation, or which may delay the scheduled completion of the work.Clean all work areas and maintain tools and maintenance equipment.Attend any designated training courses as required by the Company to maintain or improve his or her skills for required mechanical and/or E&I maintenance.Maintain a working familiarity with all plant processes and equipment and relation to critical equipment.Comply with all federal, state, and local environmental, health, and safety regulations and requirements.Comply with company policies and procedures.Perform other duties as assigned or required.Assist as needed to Install, troubleshoot, maintain, clean, and overhaul rotating equipment including pumps, motors, gearboxes, compressors, agitators, belt conveyors, screw conveyors, vibratory conveyors, bucket elevators, fans, blowers, rotary valves, couplings, belts/sheaves, chains/sprockets, hammer mills, etc.Assist as needed to Install, troubleshoot, fabricate, maintain, clean, and repair stationary equipment including piping, valves, piping supports, insulation, sheet metal, angle iron, heat exchangers, cooling towers, tanks, pressure vessels, ladders, grating, trenches, handrails, doors, etc.Assist as needed to Troubleshoot and maintain lube oil systems, shaft sealing systems, and overall equipment/system performance.